[. . . ] This appliance is manufactured to conform to the Low Voltage Electrical Equipment (Safety) Regulations 1989 and is designed to comply with BS 3456. A b c d e f f1 f2 f3 g h i i1 j Removable water tank with lid Function selector Start/ stop switch «Steam» function button « » Temperature indicator light Capsule holder head opening and closing handle capsule cage capsule holder Steam /hot water nozzle Cappuccino accessory Drip tray with removable grille fill indicator Container for used capsules Please read these instructions carefully before using your appliance for the first time and retain them for future use: any use which does not conform to the instructions will absolve KRUPS from any liability. The use of this appliance by young children or by disabled persons must be supervised at all times. [. . . ] Raise the handle (f1) to eject the used capsule which will automatically be collected in the container (j). tips : · Water quality is vital for a good espresso, so we recommend that you use only fresh cold water. Preheat the cups before making espresso, as this will help it to retain its temperature. A simple way to do this : first fill the cups with hot water (see paragraph «The Hot Water Function »). Easily obtain milk with more or less froth to make a cappuccino or a café crème, . The tip must not touch the bottom of the container so as not to prevent the passage of steam. Once you have obtained the foam, reset the function selector (b) to the central position and remove your jug. Immediately after use, remove the cappuccino accessory (h) and clean the steam/hot water nozzle (g) using a damp sponge. You can also produce steam for a moment, pointing the nozzle (g) towards the grille, in order to eliminate any remaining trace of milk. Fill the tank (a) with fresh water (1) and position the switch (c) to «I». Press the « » function button (d) : the temperature indicator light (e) turns yellow and flashes. Once the appliance reaches the correct temperature, the temperature indicator light (e) becomes fixed (yellow). Then immerse the tip of the steam/hot water nozzle (g) in the container holding the liquid to be heated (5). For any liquid other than water, clean the steam/hot water nozzle (g) immediately after use with a damp sponge. You can also produce steam for a moment, pointing the nozzle (g) towards the grille, in order to eliminate any remaining trace. Fill the tank (a) with fresh water (1) and position the switch (c) to «I». [. . . ] Use the following method : The appliance must be plugged in but switched off (swtich (c) on «0»). Take off the capsule holder (f3) (8a/8b) and lower the handle (f1) (2). Remove the grille and the fill indicator (i1), take out the container and empty the drip tray (6). [. . . ]